Tone Parameter Settings - Casio CTK-6300in User Manual

Using the Tone Editor

Tone Parameter Settings

The table below shows the parameters that can be configured on the tone editor screen. For information about each parameter,
also refer to "Tone Creation Overview" (page E-43).
The settings marked with an asterisk (*) in the "Setting Range" column are initial defaults.
Parameter Name
AttackTime
(Attack Time)
ReleasTime
(Release Time)
CutOff
(Cutoff Frequency)
Vib.Type
(Vibrato Type)
Vib.Depth
(Vibrato Depth)
Vib.Rate
(Vibrato Rate)
Vib.Delay
(Vibrato Delay)
Oct.Shift
(Octave Shift)
Volume
(Volume)
TouchSense
(Touch Sense)
Rev.Send
(Reverb Send)
Cho.Send
(Chorus Send)
E-46
Specifies the time until a note starts to sound after a key is pressed.
Specifies the time a note continues to sound after a key is released.
Adjusts timbre by attenuating note components that are higher than a certain
frequency. A larger value produces a brighter, harder sound, while a lower
value produces a mellower, softer sound.
Specifies the vibrato type (vibrato waveform).
Setting
Sin Sine wave
Tri Triangle wave
Saw Sawtooth wave
Sqr Square wave
Specifies how much vibrato is applied to a note.
Specifies the speed of the vibrato applied to a note.
Specifies how much time elapses until vibrato starts.
Shifts the pitch upwards or downwards in octave steps.
Specifies the volume level of all tones. A larger value sets a higher volume
level.
Specifies how much the volume changes in accordance with the relative
amount of pressure applied to keyboard keys. A larger positive value results
more change in volume in accordance with key pressure. A larger negative
values results in less change in volume in accordance with key pressure. Key
pressure does not affect volume when a value of 0 is set.
Specifies how much reverb is applied for each tone.
Specifies how much chorus is applied for each tone.
Description
Description Waveform
Setting Range
*
–64 to 0 to +63
*
–64 to 0 to +63
*
–64 to 0 to +63
*
Sin , Tri, Saw, Sqr
*
–64 to 0 to +63
*
–64 to 0 to +63
*
–64 to 0 to +63
*
–2 to 0 to +2
*
0 to 127
*
–64 to 0 to +63
*
0 to 40 to 127
*
0 to 127