Casio AT-5 User Manual page 104

Using the Pattern Sequencer
To edit an existing rhythm
1.
Perform steps 1 through 6 under "To rehearse
before editing an existing rhythm" (page E-99).
2.
Perform the procedure under "To configure
pattern rec settings (Rec Menu)" (page E-101).
• This step is not necessary if you want to perform
operations using initial default settings or if you want to
use previous settings without changing them.
3.
Press the L-14 (NORMAL/FILL-IN) or L-15
(VARIATION/FILL-IN) button to select the
accompaniment pattern you want to edit.
• You cannot edit the INTRO or ENDING
accompaniment pattern of an existing rhythm. If you
want to create a new accompaniment pattern (INTRO,
ENDING, etc.) from this point, see "To create a new
accompaniment pattern" (page E-104) or "To create a
new rhythm from scratch" (page E-106).
4.
Use the R-17 (u, i) buttons to select the
instrument part you want to edit.
Currently selected accompaniment pattern
Currently selected instrument part status
See "Instrument Part Editing and Rec Areas" (page E-97).
5.
Configure mixer settings for the selected
instrument part. You can skip this step if you do
not want to configure mixer settings.
• Here you can press the L-17 (START/STOP) button to
start playback of the accompaniment pattern and
configure mixer settings as you monitor the effects of
the settings on the notes being played.
E-102
Currently selected instrument part
(1) Press the C-7 (MIXER) button to display the mixer
screen.
(2) Use the R-17 (t, y) buttons to select one of the
items described in the table below and then use the
dial or R-14 (–, +) buttons to change the setting.
Display:
Item name
TONE: Specifies the instrument part
Part tone tone.
Part: Toggles an instrument between
Part On/Off sounding (on) and not sounding
*2
(oFF).
Volume: Specifies the instrument part
Part Volume volume.
Pan: Specifies whether the sound of
Part Pan the part can be heard from the
left side or right side.
Reverb: Specifies the level of reverb
Part Reverb (page E-33) applied to the
Send instrument part.
Chorus: Specifies the level of chorus
Part Chorus (page E-33) applied to the
Send instrument part.
*1 You can select any preset tone. Only drum set sounds
(tone numbers K:129 through K:147) can be selected for
drum parts and percussion parts. Drum set sounds
cannot be selected for the bass and the Chord 1 through
Chord 5 parts.
*2 You can temporarily sound the notes of individual parts, if
you want. For details, see step 5 under "To rehearse
before editing an existing rhythm" (page E-99).
*3 A smaller value shifts the pan position to the left while a
larger value shifts to the right. A value of zero specifies
center.
(3) To exit the mixer, press the C-7 (MIXER) button or the
R-15 (EXIT) button.
• This returns to the pattern sequencer screen.
Setting
Setting
Range
*1
oFF, on
000 to 127
–64 to 00 to
*3
+63
000 to 127
000 to 127