Editing A Track - Casio AT-5 User Manual

Using the Song Sequencer

Editing a Track

The following operations are supported during track (system
track, Tracks 01 through 16) editing.
• Clearing a single track
• Copying one track to another track (Tracks 01 through 16
only)
• Combining two tracks into a single track (Tracks 01 through
16 only)
To start a track editor operation
1.
Press the C-5 (SONG SEQUENCER) button to
enter the song sequencer mode.
2.
While holding down the R-13 (FUNCTION)
button, press the C-5 (EDIT) button to display
the edit menu.
3.
Use the R-17 (t, y) buttons to move the 0 to
"TrackEdit" and then press the R-16 (ENTER)
button.
• This displays the track editor menu shown below.
E-80
To clear a single track
1.
Perform the procedure under "To start a track
editor operation" on page E-80 to display the
track editor menu.
2.
Press the R-16 (ENTER) button.
• This causes the "Clear Track" screen to appear.
3.
Use the dial or R-17 (u, i) buttons to specify
the track you want to clear.
• A black box ( ) above a track number in the level
meter indicates that there is already data recorded in
that track.
• You also can select a track using the dial or R-14 (–, +)
buttons.
4.
Press the R-16 (ENTER) button.
5.
In response to the "Sure?" message that
appears, press the R-14 (YES) button to clear or
the R-14 (NO) button to cancel.