Casio AT-5 User Manual page 86

Using the Song Sequencer
■ Event Data List
The following table shows the event types that correspond to the abbreviations that appear on the display, as well as the
parameters of each event type and setting ranges.
• " 2 display" and " 4 display" in the table headings correspond to the
E-83).
2
• " display during insert" in the table headings indicates the event type name enclosed in thick brackets (%) when step 3 of
insert event procedure under "To insert an event" (page E-89).
System Track and Track 01 to 16 Common Events
Event Type
2 display Event Name
TOP (song start point)
*1
Note
Bend Pitch Bender
Mod Modulation
Sus Sustain Pedal
Soft Soft Pedal
Sost Sostenute Pedal
ModB Modulation Button
END (song end point)
*1 A note event is not displayed as the event name at position
*2 "C-" on the display indicates C-1 (one octave below C0).
*3 This event can be added only with the operation under "To insert an event" (page E-89). It applies vibrato.
Track 01 to 16 Events
Event Type
2 display Event Name
TONE Part Tone
Vol Part Volume
Pan Part Pan
CTun Part Coarse Tune
FTun Part Fine Tune
BndR Part Bend Range
RSnd Part Reverb Send
CSnd Part Chorus Send
SclE Part Scale Enable
DspL Part DSP Line
Exp Expression
*4 This event can be added only with the operation under "To insert an event" (page E-89). It changes the volume.
E-84
2
display during
insert
–
[Note]
[Bend]
*3
[Modulat]
[Sustain]
[Soft]
[Sostenu]
[ModBttn]
–
2
display during
insert
[Tone]
[Volume]
[Pan]
[CrsTune]
[FinTune]
[BendRng]
[RevSend]
[ChoSend]
[ScaleEn]
[DspLine]
*4
[Express]
2 , 4 screen positions under "Reading Event Data" (page
4 display Parameter Name
–
NOTE Note name
GATE Gate time
VEL
VALU Pitch Bender
VALU Modulation
VALU Sustain Pedal
VALU Soft Pedal
VALU Sostenute Pedal
VALU Button On/Off
–
2 , but rather as the note name (C4, etc.).
4
display Parameter Name
VALU Tone Number
VALU Part Volume
VALU
VALU Part Coarse Tune
VALU Part Fine Tune
VALU Part Bend Range
VALU Part Reverb Send
VALU Part Chorus Send
VALU Part Scale Enable
VALU Part DSP Line
VALU Expression
Setting Range
– (Not editable)
C- - C0 - G9
00:00 - 99:95
Velocity 001 - 127
–8192 - 0000 - +8191
000 - 127
000 - 127
000 - 127
000 - 127
on, oFF
– (Not editable)
Setting Range
A:001 - L:100
000 - 127
Part Pan –64 - 00 - +63
–24 - 00 - +24
–99 - 00 - +99
00 - 24
000 - 127
000 - 127
on, oFF
on, oFF
000 - 127
*2