Casio AT-5 User Manual page 39

DSP Parameter Settings
The table below shows the parameters that can be configured on the DSP editor screen.
The settings marked with an asterisk (*) in the "Setting Range" column are initial defaults.
Parameter Name
Parameters 1 through 8
DSP RevSend
(DSP Reverb Send)
*1
Mod Button Assign
(Modulation Button Assign)
*1
Mod Button On Value
(Modulation Button On Value)
*1
Mod Button Off Value
(Modulation Button Off Value)
*1 Included in the "Mod Button" group. To change the settings of these parameters, move the 0 to "Mod Button" and then press
the R-16 (ENTER) button. Next, use the R-17 (t, y) buttons to move the 0 to the parameter whose setting you want to
change.
*2 Setting range depends on the selected DSP type.
*3 Depends on the selected DSP type and the "Mod Button Assign" setting.
The number of parameters and settings available for each parameter
depends on the DSP type. For details, see "DSP Parameter List" (page
E-152).
Specifies how much of the post-DSP sound should be sent to reverb.
Specifies the function assigned to the S-2 (MODULATION) button when
"DSP" is selected for the "Mod Setting" tone parameter (page E-48).
Specifying a value from 1 through 8 assigns the corresponding DSP
parameter (1 through 8). Nothing is assigned to the button when "oFF" is
selected for this parameter.
Specifies how the function currently assigned to the S-2
(MODULATION) button works while the button is depressed.
Specifies how the function currently assigned to the S-2
(MODULATION) button works while the button is released.
Applying Effects to a Sound
Description Setting Range
–
*
0 - 40 - 127
* *2
oFF , 1 - 8
*3
*3
E-37