Table of Contents
Advertisement
12
Find the battery charger and domestic power cable in the
small parts box. Locate the charging port on the drive side
of the battery. Pull back the rubber cover and plug in the
charging cable.
14 - Install the KickBack 3
Remove the KickBack3 packaging and locate the included
hardware kit consisting of two U-bolts, a rectangular
mounting plate, four M6 washers & nuts, and an M5
set-screw.
13
Make sure the charge indicator lights begin to blink green.
A full charge will take a few hours but you will be able to use
the battery with a partial charge by the time you are done
setting up your bike.
Please note: It is also possible to charge the battery while
it is installed on the bike, but for the initial assembly you
will need the extra room.
Also note that the battery will not supply power while it
is charging.
15
Under your bike find the kickstand mounting shelf and the
threaded set-screw hole.
5
Advertisement
Table of Contents
