Table of Contents
Advertisement
32 - Adjust handlebars
Remove the rubber plug on the top-cap, and use a 5 mm
Allen wrench to loosen the bolt.
Use a 4 mm Allen wrench to loosen the two bolts holding
your handlebar stem in place.
34
Use a 4 mm Allen to loosen the faceplate on the front of your
stem, and center the positioning target. Then retighten
the faceplate.
33
Align your handlebars with your front wheel.
Re-tighten the two stem bolts, and the top-cap bolt and
replace the rubber plug.
35
Use a 3 mm Allen wrench to loosen the paddle grips.
Reposition them so they are level with the ground. Then
retighten them.
10
Advertisement
Table of Contents
