Table of Contents
Advertisement
If you would like to switch the width setting
on your U-Tubes to narrow or wide:
Press the spring pin button in and push or pull the spring
pin elbow on the inside of the U-Tube until the button pops
through the width setting hole you desire. Needlenose pliers
might be needed to help with this.
Wide
Front
setting
insertion
hole
end
41
If your U-tubes do not seem to easily slide into the frame, you
will need to loosen the tailpiece on the back end of the bike
in order to acquire additional tolerance. This is the tail piece.
Narrow
setting
hole
Rear
insertion
end
40
The U-tubes should easily slide into the mounting holes.
But it is possible an adjustment will be needed if the fit the
alignment is not perfect. If no adjustment is needed skip to
step 44.
42
Four bolts secure the tailpiece in place. Loosen these
four bolts using a 10 mm socket wrench and a 5 mm
Allen wrench.
12
Advertisement
Table of Contents
