Table of Contents
Advertisement
5. Commissioning
When the device series XP-504 is used as intended, it will often be installed in a
machine or system to function as controls and will be wired accordingly.
In this case, the devices will need to be switched on and off using the corresponding
machine controller.
DANGER!
Electric shock hazard!
When setting up and testing the visualization interface, make sure to
use a test environment that is fused as per the state of the art and in
accordance with all applicable standards in order to power the
devices.
The XP-504 will boot up as soon as it is energized.
If the XP-504 will not start, or if an error message appears, consult the → Section
"Faults", page 99 section.
The XP-504 will be shut down as soon as it is not being powered.
CAUTION
SHORT-CIRCUIT HAZARD
If the device is or has been exposed to environmental fluctuations
(ambient temperature, air humidity), condensation may form on or
inside it. As long as this condensation is present, there will be a
short-circuit hazard.
Do not switch on the device when it has condensation in or on it.
If the device has condensation in or on it, or if the panel has been
exposed to environmental fluctuations, let the panel settle into the
existing ambient temperature before switching it on. Do not expose
the device to direct thermal radiation from heating appliances.
Power the XP-504 with 24 VDC.
The XP-504 unit will boot up. As soon as the operating system loads, the application
will start.
XP-504 04/2022 MN048028EN Eaton.com
5. Commissioning
83
Advertisement
Table of Contents
