Box-Pc; Mounting Position; Extender Tx - Eaton XP-504-10-A10-A01-2B Manual

Table of Contents

3. Installation

3.2 Installation position

3.2.2 Box-PC

3.2.2.2 Mounting position

3.2.3.1 Mounting position

3.2.3.2 Mounting position

The XP-504-BOXPC-... is designed to be vertically flush-mounted in control cabinets.

A mounting bracket is used for installation on the DIN-rail in the control cabinet.

Alternatively, the device can be installed in a horizontal or vertical position on a

mounting wall with the help of the two mounting plates.

The mounting wall where the Box-PC is installed must be able to

bear four times the device weight, including the corresponding

retaining elements.

The device can be mounted horizontally and vertically provided that the required air-

flow clearances are maintained.

Make sure to install the device in the right position.

Fig. 10: Mounting positionBox-PC

Correct mounting position: Power connector at the bottom or heat sink at the top.

The controls and connectors must remain accessible even after the device has

been installed.

The interfaces are located on the front of the Box-PC.

Make sure to consider the space required to remove the SD card

and replace the battery, as well as the space needed for the inter-

face connections.

The Extender TX is designed to be vertically flush-mounted in control cabinets.

A mounting bracket is used for installation on the DIN-rail in the control cabinet.

Only vertical mounting is allowed, and all airflow clearances must be maintained.

XP-504 04/2022 MN048028EN Eaton.com

Table of Contents