Ethernet - Eaton XP-504-10-A10-A01-2B Manual

4.4 Ethernet

Available on: Panel-PC and Box-PC.
The RJ45 sockets on Terminal with Extender RX and Extender TX
are used by the transmitter/receiver cable.
The Ethernet interfaces are designed as CAT 5e/6 interfaces according to the
ANSI/TIA-568 standard.
Make sure to use compatible standard RJ45 Ethernet cables only.
The Ethernet controllers support transfer rates of 1000/100/10 Mbit/s.
ETH2/LAN
8 7 6 5 4 3 2 1
Fig. 35: LAN connections, e.g. on the Panel-PC
The XP-504 is only allowed to be connected to internal Ethernet net-
works without this closed network being left or being subordinate
to TNVs.
When the green LED lights up, this means that an active network has been detected
and a LINK (2) to it has been established. When the yellow LED (1) flashes, this
means that data is being transferred.
For the network, use shielded twisted-pair (STP) cables only.
For connecting XP-504 devices, use a one-to-one patch cable.
Maximum cable length: 100 m.
CAUTION
FORCES ON THE RJ45 INTERFACE
Communications may be affected, and the connection's mechanical
components may be damaged, if the RJ45 interface is subjected to
strong vibrations or the RJ45 plug-in connection is subjected to
pulling.
Protect the RJ45 plug-in connection from strong vibrations.
l
Protect the RJ45 plug-in connection from tensile forces at the
l
socket.
Eaton recommends implementing measures for protecting against cyberattacks.
Eaton cyber security
Eaton.com/us/en-us/company/news-insights/cybersecurity.html
Eaton.com/cybersecurity
XP-504 04/2022 MN048028EN Eaton.com
4. Using peripheral devices - External connections
ETH1/LAN
4.4 Ethernet
77