Electrical Wiring - Hayward WFBRNDBRS Owner's Manual

Electrical Wiring

The Water Bowl's LED Light requires the use of a low voltage transformer (not included). See chart
below to determine the type of transformer you will need based on the number of LED Lights used.
When considering the number transformers required, note that
on a transformer should not exceed 80%
NOTE: Any lights wired to the same transformer will run together. If independent operation is
desired, then each light or group of lights will require their own separate transformer and relay.
Wiring Overview
Refer to the wiring overview diagram below and the steps on the following pages for wiring instruc-
tions.
LED Light
Assembly
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
of the maximum wattage.
Number of Lights Type of Transformer
1-2
3-9
10+ Multiple Transformers
High Voltage from
Manual Wall Switch
Or
Omni Control Relay
LJBUY00PP1
Junction Box
Service Loop
Grommet
Total distance of cable between LED Light
and Transformer should not exceed 150 feet.
one LED Light is 25W
70W
300W
Low Voltage
Transformer
Hayward
and the load
6