Part No ISCLSERIES Rev: B SERIES CL100/110 SERIES CL200/220 AUTOMATIC CHLORINE FEEDERS Owner’s Manual IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death. This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the following signal words and be alert to the potential for personal injury.
Page 2
Do not operate pool and spa circulation system unless filter manual air relief valve body is in locked position in filter upper body. USE ONLY GENUINE HAYWARD PARTS Page 2 of 8...
Page 3
The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its’ pool products and is in lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be responsible for any consequential, special or incidental damages of any nature.
If the chlorine feeder is located below water level, you may want to install a check valve to prevent water backflow when operating/servicing the unit. The CL100 has this feature built in. 3. Both the CL–100/200 are furnished with 1 1/2” female threads. If PVC socket (solvent weld) connections are desired, order SP1500UNPAK2, socket flush union end connectors package.
If these products must be used, they should be added directly into the pool water. Never isolate chlorine feeder with valves or other devices. WARNING Wear eye and skin protection while maintaining or servicing this unit. USE ONLY GENUINE HAYWARD PARTS Page 5 of 8 AUTOMATIC CHLORINE FEEDERS ISCLSERIES REV B...
Pry off Logo Cap, located on the cover of the chlorinator. Unscrew and remove retainer screw. Cover may now be slipped free of the Cover Cap. Replace O-ring with a Genuine Hayward Part O-ring (part no. CLX200K). Reassemble being sure Slip Washers are in place on stem of Cover (inside), and under head of Retaining Screw.
New Installation Replacement ® Please include me on all e-mail communications regarding Hayward Equipment or promotions. Mail to: Hayward Pool Products, 620 Division Street, Elizabeth, NJ 07207 Installation for: Attn: Warranty Dept In Ground Above Ground Or REGISTER YOUR WARRANTY ON-LINE AT WWW.HAYWARDPOOL.COM...
Need help?
Do you have a question about the CL100 and is the answer not in the manual?
Questions and answers