Replacement Parts - Hayward WFBRNDBRS Owner's Manual

3. Screw in a 11/2" threaded plug to the center of the bowl.
4. Cover the bowl or fill it with pool anti-freeze.
LED Light Replacement
Follow the steps below to replace the LED Light assembly in an existing installation.
1. Remove all power from the LED Light system and disconnect the wires from the LED Light at
the junction box/low voltage transformer.
2. Completely drain any water from the bowl.
3. Unscrew the water spout assembly from the center of the bowl, revealing the retaining nut on
the bulkhead assembly.
4. Unscrew and remove the retaining nut and gasket from the center of the bowl to release the
bowl.
5. With two people, remove the bowl by lifting it straight up and carefully set it aside.
6. Remove the old LED Light assembly from the niche and pull the cord out.
7. Install the new LED Light assembly by following the Electrical Wiring steps starting on page 7.
8. Restore power to the LED Light system and turn the LED Light on to verify operation.
9. Re-install the bowl onto the Niche pipe followed by the gasket, retaining nut, and water spout
assembly.
Bowl Replacement
Follow the steps below to replace the bowl in an existing installation.
1. Turn off water flow to the Water Bowl system and completely drain any water from the bowl.
2. Unscrew the water spout assembly from the center of the bowl, revealing the retaining nut on
the bulkhead assembly.
3. Unscrew and remove the retaining nut and gasket from the center of the bowl to release the
bowl.
4. With two people, remove the old bowl by lifting it straight up and set it aside.
5. Install the new bowl with the foam gasket onto the niche pipe.
6. Re-install the gasket, retaining nut, and water spout assembly in the center of the new bowl.
13
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Replacement Parts

Part No.
GLXWBNICHE Bowl Niche Replacement Kit
GLXWBGSK Bowl Gasket Replacement Kit
GLXWBBKHD Bowl Bulkhead and Nut
Description