Electrical Installation And Wiring - Hayward AquaRite+ AU Master Installation And Setup

Electrical Installation and Wiring

Master Unit Slave Unit
FL1
FL1
12+ 12+
5 6 7 8 9 10
1 2 3 4
7 8
Flow Switch
Master Unit
Flow Switch
Slave Unit
Wiring Schematic Only
NOTE - Ensure that only 0.5 mm² to 0.75 mm² double insulated cable is used to bridge between the Master
and Slave units. The Slave unit flow switch cable is to be connected/joined to the bridging cable and
terminals inside the Slave Control unit.
The above diagram is a schematic only, and the flow switch wire is not to be pulled apart into to seperate
single insulated conductors further than what is required to make the joins/connections inside the Slave
unit housing.
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 7