Installation Of Instrument Control Software; Defining The Instrument Settings; Installation Of "Sunrise Instrument Settings" Software; Starting The "Sunrise Instrument Settings - tecan SUNRISE Instructions For Use Manual

3.7

Installation of Instrument Control Software

3.8

Defining the Instrument Settings

Installation of "SUNRISE Instrument Settings" Software

3.8.1

Starting the "SUNRISE Instrument Settings"

3.8.2
2021-07
For more information about installing the software, see Magellan or
XFluor4 Instructions for Use, which can be found on the software CD.
This program enables the user to define the settings of:
• Instrument modes
• Filter definition
• Measurement modes
IF USED IN THE IVD ENVIRONMENT, ONLY THE AUTHORIZED
PERSON IS ALLOWED TO CHANGE AND DEFINE THE "SUNRISE
The "SUNRISE Instrument Settings" software is installed using the following
procedure:
1. Insert Tecan Detection Suite CD into the required CD ROM drive.
2. The setup dialog box is displayed. Click the service and settings button. Click
the setup button for the "SUNRISE Instrument Settings". The installation
program is started, which installs "SUNRISE Instrument Settings" onto your
computer
3. A series of dialog boxes will appear, read each one, enter any necessary
information and click Next to continue.
4. The files are then installed, and the program icon is created.
5. When the Installation Complete dialog box appears, click Finish and the
"SUNRISE Instrument Settings" program is ready to be used.
In case an instrument is already connected to one of Tecan's programs, close the
program or disconnect the instrument.
The "SUNRISE Instrument Settings" software is started by clicking the "SUNRISE
Instrument Settings" icon on the desktop if present or go to Start – Programs –
Tecan – and select "SUNRISE Instrument Settings".
The following dialog box appears:
Instructions for Use for SUNRISE No. 30086638 Rev. No. 2.9
Note
CAUTION
INSTRUMENT SETTINGS".
3. Installation Procedure
33