Appendix E. Information For Trained Service Personnel; Removing A Drive From An Enclosure; Removing The Internal Drive - IBM System Storage TS2240 Tape Drive Setup, Operator, And Service Manual

Appendix E. Information for Trained Service Personnel

Attention
v
v These procedures must be performed only by a trained IBM service
v Inform the customer the following procedure has high risk of damaging the

Removing a Drive from an Enclosure

Depending on the type of enclosure, removal procedures may vary. The following
generic procedure can be used if the enclosure documentation is not available for
the different enclosure types.

Removing the Internal Drive

This Procedure is to be performed by IBM Service Personnel only.
Step 1. Remove the Cover
1. Unplug all cables from the rear panel of the unit.
2. Move the unit to a clean and sturdy work surface.
3. Turn the unit on its side with the bottom of the unit facing you.
4. Remove the 4 screws ( 1 in Figure E-1 on page E-2) by the feet.
© Copyright IBM Corp. 2007
It is strongly recommended that the drive and stuck tape be returned to
IBM for removal and recovery.
provider. SSRs should claim their time against service code 33 ECA 013
when performing this procedure.
drive and high risk of not being able to recover the data.
E-1