Table of Contents
Advertisement
Figure D-1. Leader pin in the incorrect and correct positions. The cartridge door is open and the leader pin is visible
inside the cartridge.
D-2
TS2240 Tape Drive Setup, Operator and Service Manual
To reposition the leader pin, refer to Figure D-2 and perform the steps below.
1. Slide open the cartridge door ( 1 ) and locate the leader pin ( 2 )
Note: If necessary, shake the cartridge gently to roll the pin toward the door.
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
pin-retaining spring clips ( 3 ).
3. Press the leader pin gently into the clips until it snaps into place and is firmly seated.
4. Close the cartridge door.
5. Ensure that there are no gaps in the seam of the cartridge
Figure D-2. Placing the dislodged leader pin into the correct position
Advertisement
Table of Contents
