Do Calibration; Initializing The Penmount Driver; Demonstration - Advantech FPM-3150 Series User Manual

If you do not need to detect IRQ5 and IRQ9, the command is:
C:\PENMOUNT\PMDETECT -N5 -N9
A.3.3.3 Do Calibration
A.To adjust touch screen mapping properly for the display, use
PM.BAT (C:\PENMOUNT\PM ) tocalibration.
B. Choose "1" DO CALIBRATION (adjust screen mapping).
C. The message on the pop up window asks you to select video mode
number. Select by keyboard to start the calibration, touch the upper-
center point, then right-center point, bottom-center point and left-
center point in sequence. After calibration, the data will show in the
screen. Press any key to continue the progress.
D.After the calibration, suggest you to test touch screen and display
mapped results by choose "3" DRAWING TEST under PM.BAT
A.3.3.4 Initializing the PenMount driver
A.If you don't have the initialization commands in AUTOEXEC.BAT,
initialize the PenMount controller before you use the PenMount
Touch Screen.
C:\PENMOUNT\PMINIT
The display will show the initialization message :
PenMount V7.06 Copyright(c) SALT International Corp.
Test:COM<n> IRQ<n> (<n> is the number after PMDETECT done)
PenMount communication settings: COM<N> IRQ<n> Baud Rate:
<xxxx>
... ... ... ... ... ... ... ... ... ...
A.3.3.5 Demonstration
To demonstrate or test touch screen operation, select "3" DRAWING
TEST in PM.BAT file of Utility Directory. Drawing on screen.
The other demonstration program called "ICECREAM.EXE" in the
Appendix A Touchscreen Driver Installation 21