Adcon A850 User Manual page 40

Telemetry Gateway A850 User Manual
8.
9.
10. Specify the location of your RTU:
Note Use a GPS app or enter the approximate coordinates and then hold down the
mouse button to move the device or the map to the desired spot. To determine
the exact location you can also zoom [CTRL + scroll].
11. Click Next. A popup window opens where you can configure the
Note Different dialog boxes open depending on the type (UHF or GPRS). A GPRS RTU
is displayed below.
Note The authentication code serves as the password for the RTU. If you leave the
value set to 0, the authentication code set on the RTU is ignored (not
recommended; use only for troubleshooting, for example if you forget the
password or the password was not set).
12. Click Finish. The new RTU is added to Explorer.
13. Save the configuration or delete the RTU in the context menu.
Select the RTU type (see "Basic" tab).
Click "Next". A popup window opens where you can enter the coordinates
for the RTU.
Figure 34. Entering the coordinates for the RTU
a. Enter the latitude, longitude and altitude
b. Select the location on the map
coordinates for the RTU.
Figure 35. Configuring settings for the RTU
Adding an RTU Group
,
40
CHAPTER 5