Table of Contents
Advertisement
Chapter 5. Using the Gateway
This chapter explains the necessary steps to be able to use the gateway and set
up the ADCON telemetry network.
Only system administrators (root) are allowed to configure the corresponding
settings. All other users (admin and root) can view the configured settings, but
cannot make changes – with the exception of RTU settings (see
page
CAUTION
System administrators must have the relevant IT technician qualifications and
must be authorized to make the changes. Improper handling can result in the
loss of data.
Getting Started
After installing the gateway and launching the configurator, you can start
configuring the network.
Locking the Configuration
Note
Configurations can only be made in the locked state. This prevents other users
from making conflicting changes while the gateway is being configured.
Several options are available for locking the configurator:
•
•
A popup window opens where you can enter the lock duration. You will receive a
notification before this time expires. Provide your data so that other users can
contact you. Confirm with OK. If you log in with your user profile, this data
needs to be stored in order for it to be displayed.
If you need more time to adjust the settings or are finished editing, you can
either extend or cancel the lock.
Saving the Configuration
To save the configuration, click on the Save configuration tool bar shortcut.
Note
When configurations are pending confirmation, the shortcut changes to green.
46).
Click on the Lock configuration tool bar shortcut.
Click on Gateway on the menu bar and select Lock configuration.
Figure 23. Locking the configuration
33
"Users" on
Advertisement
Table of Contents
