Table of Contents
Advertisement
Telemetry Gateway A850 User Manual
Telemetry Gateway Installation
1.
2.
Connecting the Telemetry Gateway with the Computer
To establish communication between the Telemetry Gateway and the computer,
set up the connections as shown in
•
•
Connecting to the Power Supply
Connect the power cable to the AC power supply on the rear panel of the
Telemetry Gateway and to an electrical outlet.
Once the device is connected to power, all 3 LEDs on the front panel of the
Telemetry Gateway will light up.
initializing. As soon as the default configuration is loaded, only
(after approx. 2 minutes).
Note
Before operating the Telemetry Gateway for the first time, charge the internal
battery for at least 6 hours. To do this, disconnect the connection to the A440.
Telemetry Gateway Initialization
During initialization the Telemetry Gateway is set to operating mode and is used
for the following:
•
•
Initialization is started via the web interface. Alternatively, a console interface
with a command line interface is available. A terminal program such as TeraTerm
or similar is required for communication.
Note
When the Telemetry Gateway is used in battery mode, the charge level must be
more than 75% (
Install the Telemetry Gateway on a stable, level surface.
Connect the modem cable to the
Telemetry Gateway.
Figure 6. Telemetry Gateway installation
If you are using a switch to link multiple computers to a LAN network, use a
twisted pair Ethernet cable to connect the Telemetry Gateway to the switch.
Connect the cable to the
Gateway (included in the package).
The Telemetry Gateway can also be operated directly with a standalone
computer. The null modem cable is included in the package.
The console port is used for debugging and for changing the default
configuration of the Telemetry Gateway.
Initial installation
Reconfiguration (after changes and debugging are completed)
flashes slowly).
PWR
port on the rear panel of the
RADIO MODEM
Figure
6:
port on the rear panel of the Telemetry
LAN
and
are illuminated while the device is
PWR
RUN
19
CHAPTER 3
Installation
remains lit
PWR
Advertisement
Table of Contents
