Advertisement
WIRING INSTRUCTIONS
■ TORQUE
Wiring screw for separable terminal: 0.5 N·m
Fixing screw for separable terminal: 0.5 N·m
■ SOLDERLESS TERMINAL unit: mm (inch)
Refer to the drawing below for recommended ring tongue
terminal size. Spade tongue type is also applicable. Solder-
less terminals with insulation sleeve do not fit.
Recommended manufacturer: Japan Solderless Terminal
MFG.Co., Ltd., Nichifu Co., Ltd.
Applicable wire size: 0.25 – 0.75 mm
3 max.
12 max.
■ HOW TO REMOVE SEPARABLE SCREW TERMINAL
The terminal block is separable in two pieces. Evenly loos-
en two screws on top and bottom of the terminal block to
separate.
2
3.2 dia.
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
PC CONFIGURATOR
The following parameters can be set with PC Configurator
Software (model: R30CFG). Refer to the users manual for
the R30CFG for detailed operation of the software program.
■ CHANNEL INDIVIDUAL SETTING
ITEM
USABLE RANGE
Unused setting
CH enabled
CH disabled
Input range
-10 – +10 V DC
-5 – +5 V DC
-1 – +1 V DC
0 – 10 V DC
0 – 5 V DC
1 – 5 V DC
0 – 1 V DC
-0.5 – +0.5 V DC
-20 – +20 mA DC
4 – 20 mA DC
0 – 20 mA DC
Fine zero adjustment -320.00 – +320.00 (%) 0.00 (%)
Fine gain adjustment -3.2000 – +3.2000
Scaled range Zero
-32 000 – +32 000
Scaled range Span
-32 000 – +32 000
■ CHANNEL BATCH SETTING
ITEM
USABLE RANGE
Conversion rate
80 ms
40 ms
20 ms
10 ms
Simulate input
Normal input
Simulated data
R30SV2
DEFAULT
SETTING
CH enabled
-10 – +10 V DC
1.0000
0
10 000
DEFAULT
SETTING
80 ms
Normal input
EM-9015 Rev.1 P. 5 / 5
Advertisement
