Advertisement
INSTALLATION
■ INSTALLATION TO THE BASE
Use the Installation Base (model: R30BS).
The I/O slots are numbered in the ascending order starting
from the one on the immediate right side of the network
module (slot 1, slot 2...).
A code indicating the I/O slot number is assigned to each
I/O slot and I/O data is allocated in the order of this code.
When an I/O slot is vacant, blank data is sent or received to/
from the PLC, etc.
PWR COM
I/O1
■ HOW TO MOUNT THE MODULE ON THE BASE
1 ) Engage the positioning guide of the module with the
Installation Base.
2 ) Pivot the module on the positioning guide and press it
down until the lock tab sits into place.
3 )
Tighten the base fixing screw using a screwdriver
(stem length: 70 mm/2.76" or more) (torque 0.5 N·m).
Base Fixing Screw
I/O n
Positioning Guide
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
■ HOW TO REMOVE THE MODULE
1 ) Loosen the base fixing screw using a screwdriver (stem
length: 70 mm/2.76" or more).
Base Fixing Screw
2 )
While pressing the projection on the lock tab, push the
module upward.
3 ) Detach the positioning guide of the module from the
Installation Base.
Lock Tab
R30SV2
EM-9015 Rev.1 P. 3 / 5
Advertisement
