Detection Area Settings And Walk Test; Pir Area Direction - Optex INS-HX-80N Installation Instructions Manual

Step

Detection area settings and walk test

4

4-1. PIR area direction

Remove the Back cover by hand.
1
1
Raise the Back cover up.
2
Pull it back.
Horizontal ±95°
2
Vertical 0° to -20°
1
Do not use the vertical angle adjustment of the main unit other than adjusting
the detection area surface to be parallel to the ground inclination.
NOTE Settings on the InSight web
It is possible to refer the location of the detection area following procedure.
SETUP -> PIR DETECTOR -> PIR area viewer
In this step, do not change the camera tilt angle on InSight web settings.
The display of the detection area helps to set the area.
- 6 -
Adjust PIR area direction
2
Angle can be adjusted with either left or right screw.
Caution
Pall all el Adjusting the detection range
[ Mounting height ]
3.0 m: 1 click downward
2.5 m: Default setting(No click)
IP camera settings