Optex inSight INS-HX-80N Installation Instructions

INS-HX-80N
INS-HX-80N
Camera and PIR detector
<< Contents >>
Before installation
- Parts identification
- Accessories
- Manufacture' s statement
Step
1
Installation
Enable
DHCP
Disable
2
IP address settings
IP camera settings
3
Registration InSight to CHeKT portal site
4
Detection area settings and walk test
5
Camera angle settings
6
System check
Others
- Detection area
- Specifications
- Dimensions
- Compliance
- How to reset to the factory default
Step
Installation
1
1-1. Disassemble
1 2
Page
1
2
CHeKT settings
3
4
1-2. Install a mounting plate
3
CAD 絵は線画に差替え予定
• This "Quick Guide" is the part of the entire installation instructions
that guides the installation procedures for installers.
•
Get the full information of the installation instructions in the web site.
• If you need a guide to the operation of the whole system, please
consult your installer of the entire system.
Before installation
- Parts identification
Bracket angle adjusting screw
PIR detector
PIR cover
Camera unit
- Manufacture' s statement
Failure to follow the instructions provided with this indication
Warning
and improper handling may cause death or serious injury.
Failure to follow the instructions provided with this indication
Caution
and improper handling may cause injury and/or property
damage.
Mounting height
2.5 m (8' 2" ) to 3.0 m (10' )
- 1 -
INSTALLATION INSTRUCTIONS
Full information is available at
https://navi.optex.net/manual/50427
Mounting plate
Back cover
Camera angle adjusting screw
Tilt
Hook the fall prevent wire.
59-xxxx-0 2102-18
Quick Guide
- Accessories
4 x 20 mm
Mounting screws
T20 Torx wrench
Waterproof cap
for LAN connection
Prohibition
Recommendation
NOTE
Special attention is
required to the
section of this symbol.