Advertisement
Quick Links
INS-HX-80N
INS-HX-80N
VISUAL VERIFICATION PIR CAMERA
<< Contents >>
Before installation
- Manufacturer' s statement
- Parts identification
- Accessories
- CHeKT account
Step
1
Installation
Enabled
DHCP
Disabled
2
IP address settings
InSIght Camera manual
https://navi.optex.net/manual/50427/en/?type=cameramanual
3
Device registration to CHeKT portal
4
Camera angle and PIR area settings
5
Checking
Others
- Specifications
- Dimensions
- Detection area
- Compliance
- How to reset to the factory default
series
Before installation
Page
- Manufacturer' s statement
1
2
- Parts identification
CHeKT support
https://support.chekt.com
3
4
- Accessories
- CHeKT account
If you do not have a CHeKT account, request a dealer account by visiting the
"CHeKT dealer" , before Step 3. Refer to the "CHeKT support" for more details.
INSTALLATION INSTRUCTIONS
Full information is available at
https://navi.optex.net/manual/50427
• This "Quick Guide" is the part of the entire installation instructions
that guides the installation procedures for installers.
•
Get the full information of the installation instructions from the web site.
•
If you need a guide to the operation of the whole system, please
consult the installer of the entire system.
Failure to follow the instructions provided with this indication
Warning
and improper handling may cause death or serious injury.
Failure to follow the instructions provided with this indication
Caution
and improper handling may cause injury and/or property damage.
Prohibition
Recommendation
Warning
Destroy
Disassemble
modify
Intentional watering
PIR detector
PIR cover
Camera unit
4 x 20 mm
Mounting screws
CHeKT dealer
www.chekt.com/registration
1
59-3062-1 2212-27
Quick Guide
Special attention is required to
NOTE
the section of this symbol.
Caution
Mounting on
an unstable
wall
Bracket angle adjusting screw
Mounting plate
Back cover
Camera angle adjusting screw
Waterproof cap
T20 Torx wrench
for LAN connection
CHeKT support
https://support.chekt.com
Advertisement
Related Manuals for Optex InSight Series
Summary of Contents for Optex InSight Series
- Page 1 59-3062-1 2212-27 INSTALLATION INSTRUCTIONS INS-HX-80N INS-HX-80N Quick Guide Full information is available at https://navi.optex.net/manual/50427 VISUAL VERIFICATION PIR CAMERA series • This “Quick Guide” is the part of the entire installation instructions that guides the installation procedures for installers. • Get the full information of the installation instructions from the web site.
- Page 2 3. Select the Site Devices tab. User name: root 4. Select the bridge device to be associated with the sensor camera. Default password: OPTEX 5. Access the bridge settings using the gear icon to its right. Change your password as appropriate.
- Page 3 PIR area settings. Caution InSight VCA manual If the vertical angle of the camera is to be adjusted, adjustment of this https://navi.optex.net/manual/50426/en/?type=VCAmanual sections must be matched to ensure the best performance of the sensor. 4-4. Detection range limit 4-5. Switch settings The default settings are 18 m (60') at 2.5 m (8'2") mounting height.
- Page 4 Installation of this product, producing image, monitoring, recording with camera and handling of personal information or data shall all be performed under discretion and responsibility of user of this product, and OPTEX shall not be held liable for any dispute between a user and a third party. FCC notification This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.