Optex InSight INS-QXI-ST Installation Instructions
Hide thumbs
Also See for InSight INS-QXI-ST:
- Installation instructions manual (16 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
Quick Links
INS-QXI-ST
INS-QXI-ST
Camera and PIR detector
<< Contents >>
Before installation
- Parts identification
- Accessories
- Manufacture' s statement
Step
1
Installation
Enable
DHCP
Disable
2
IP camera settings
3
4
5
6
- Detection area
Step
Installation
1
1-1. Disassemble
1
2
Page
1
2
CHeKT settings
3
4
1-2. Install a mounting plate
3
CAD 絵は線画に差替え予定
• This "Quick Guide" is the part of the entire installation instructions
that guides the installation procedures for installers.
•
Get the full information of the installation instructions in the web site.
•
If you need a guide to the operation of the whole system, please
consult your installer of the entire system.
Before installation
- Parts identification
Bracket angle adjusting screw
PIR detector
PIR cover
Camera unit
Camera angle adjusting screw
- Manufacture' s statement
Failure to follow the instructions provided with this indication
Warning
and improper handling may cause death or serious injury.
Failure to follow the instructions provided with this indication
Caution
and improper handling may cause injury and/or property
damage.
Mounting height
2.2 m (7 3 ) to 2.7 m (8 11 )
- 1 -
INSTALLATION INSTRUCTIONS
Full information is available at
https://navi.optex.net/manual/50426
Mounting plate
Back cover
Tilt
Hook the fall prevent wire.
59-xxxx-0 2102-18
Quick Guide
- Accessories
4 x 20 mm
Mounting screws
T20 Torx wrench
Section
"e"
PIR area masking strips
"e"
(Both side
are attached
to the lens in the factory)
Waterproof cap
for LAN connection
Prohibition
Recommendation
NOTE
Special attention is
required to the
section of this symbol.
Advertisement
Table of Contents
Related Manuals for Optex InSight INS-QXI-ST
Summary of Contents for Optex InSight INS-QXI-ST
- Page 1 INSTALLATION INSTRUCTIONS INS-QXI-ST INS-QXI-ST Quick Guide Full information is available at https://navi.optex.net/manual/50426 Camera and PIR detector • This “Quick Guide” is the part of the entire installation instructions that guides the installation procedures for installers. • Get the full information of the installation instructions in the web site.
- Page 2 CHeKT dealer web portal. User name: root Access to this portal allows you to install and manage Default password: OPTEX the InSight series. If you do not have an account, please request a dealer account by visiting: Refer to the “IP Camera Setting Manual”...
- Page 3 4-5. Walk test DIP switch No. 1 Turn LED back ON, if it was turned OFF ( , Default ON). Walk around the detection area to make sure it is set as intended. If necessary, turn LED OFF again. Fix the cover with the cover lock screw included in the housing, after completion as necessary.
- Page 4 Installation of this product, producing image, monitoring, recording with camera and handling of personal information or data shall all be performed under discretion and responsibility of user of this product, and OPTEX shall not be held liable for any dispute between a user and a third party. FCC notification This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Need help?
Do you have a question about the InSight INS-QXI-ST and is the answer not in the manual?
Questions and answers