Canon FINISHER - D1 Service Manual page 98

CHAPTER 3 MECHANICAL SYSTEM
2) Open the front cover. Remove the screw
[2], and detach the spanner [1] from behind
the front cover.
3) Remove the two screws each [4], and de-
tach the foot cover (front, rear) [3].
E.2 Correcting Tilt A
1) Loosen the fixing nut by turning it in the
direction of arrow C. Turn the adjusting
foot of the caster in the direction of arrow
D several times. Perform this for both front
and rear feet.
3-10
COPYRIGHT © 1999 CANON INC.
[4]
C
Fixing nut
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]
Figure 3-120
[3]
[4]
[3]
Figure 3-121
D
Adjusting foot
Figure 3-122