Basic Operations; Specifications - Canon FINISHER - D1 Service Manual

I . BASIC OPERATIONS
A.

Specifications

The finisher is designed to receive sheets from its host copier and deliver them after performing
specific jobs on them: i.e., non-sort stacking, job offset (Note), and stapling.
The series of operations are controlled by the finisher controller PCB, and some of them are
driven in response to various commands from the copier.
Caution:
The term "job offset" refers to shifting each arriving stack toward the front or rear slightly
away from the previous stack, thereby sorting the sets.
COPYRIGHT © 1999 CANON INC.
Figure 2-101
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 OPERATIONS
Swing guide
control system
Alignment
control system
Stapler control
system
Delivery control
system
Feeding control
system
Tray control
system
Inlet control
system
Buffer control
system
2-1