Table of Contents
Advertisement
CHAPTER 5 TROUBLESHOOTING
9) Press SW104 once to store the new adjust-
ment value.
• Stapling will occur automatically so that
you can check the stapling position.
LED101 will indicate '0'.
10) Turn off the power.
11) Shift all bits of SW103 to OFF.
12) Turn on the power, and move down the
swing guide.
4.
Adjusting the Stapling Position
(rear 1-point stapling)
If you have replaced the EEPROM
(IC102) on the finisher controller PCB or the
stapler, perform the following:
1) Set SW103 on the finisher controller PCB
as follows:
AB Configuration
ON
1
2
3
Inch Configuration
ON
1
2
3
Figure 5-108
2) Press SW104 on the finisher controller
PCB.
• The swing guide of the machine will open
and, at the same time, the front jogging
plate and the rear jogging plate will move
to the home position. Thereafter, the front
jogging plate and the rear jogging plate
will move to the rear 1-point stapling po-
sition. The stapler will also move to the
rear 1-position stapling position. LED101
on the finisher controller PCB will indi-
cate the present value, which is between
'-12' and '14'.
3) Insert a stack of several A4 or LTR sheets
into the processing tray. At this time, be
sure to butt the rear edge of the stack
against the rear jogging plate.
5-4
COPYRIGHT © 1999 CANON INC.
4
5
6
7
8
4
5
6
7
8
• If the gap between the front jogging plate
and the front edge of the stack is 1 mm or
more, turn off the power, shift all bits of
SW103 to OFF, and stop the adjustment
work. Perform the alignment width ad-
justment, and then perform the stapling
position adjustment once again.
4) Press SW104 on the finisher controller
PCB.
• Stapling will take place, and LED101 will
indicate '0'.
5) Take out the stack of sheets, and check the
position of the staple against the standard.
If the position is correct, end the adjust-
ment work, i.e., turn off the power, shift
all bits of SW103 to OFF, and then turn on
the power. If the stapling position must be
adjusted, go to the next step.
Direction of delivery
6) Press SW104 once so that you can enter a
new value.
• The stapler will return to the home posi-
tion, and then will return to the stapling
position once again. LED101, on the other
hand, will indicate the present value.
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 5-109
Figure 5-110
Advertisement
Table of Contents
Troubleshooting
