Canon FINISHER - D1 Service Manual page 97

E. Removing the Slope
You may have to remove the tilt caused by
floor conditions by performing the following;
be sure to adjust the height before performing
the steps:
E.1 Checking the Tilt
1) Check to find out in which direction the
machine tilts.
• The gap between the machine and the
copier must be 5 +0, -3 mm. If the gap is
wider, identify the condition as tilt A, and
perform the steps under E.2; if the gap is
narrower, on the other hand, identify the
condition as tilt B, and perform the steps
under E.3.
Reference:
To correct the tilt, turn the two casters
shown in Figure 3-119.
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
Gap at the bottom:
Figure 3-118
Figure 3-119
5+0, -3 mm
3-9