C.Plath NAVIGAT X MK 1 Mod. 10 Operator's Manual page 50

NAVIGAT X MK 1 Mod. 10 / SR-180 MK 1 Mod. 10
Page 5-06
5) Unscrew the captive screws attaching the
two halves of the gyroshere container.
6) Remove the upper section of the
gyrosphere container and place it upside
down on the work surface.
Caution:
Do not damage the golden contact pins.
7) Open the gyrosphere transport box, re-
move the top foam rubber pad and place it
with the recess uppermost on the work
surface.
8) Remove the gyrosphere from the transport
box and place it in the foam rubber pad.
9) Take the plastic bowl from the replacement
parts kit and place it on the work surface.
10) Remove the protective sticker from the re-
cess of the gyroshere. Placing a thumb in
the recess, lift the gyrosphere out of the
foam rubber pad and place it on the plastic
bowl.
056310
3-149 MK110ENG.P65