Analogue Rate Of Turn Output; Rudder Angle Feedback Inputs - C.Plath NAVIGAT X MK 1 Mod. 10 Operator's Manual

NAVIGAT X MK 1 Mod. 10 / SR-180 MK 1 Mod. 10
Sensor Data / Magnetic Heading Output Format (Sens. D. M. outp.)
Settings:
Function:
Note:
4.6.3

Analogue Rate Of Turn Output

Settings:
Function:
Note:
4.6.4 Rudder Angle Feedback Inputs (Feedback signal)
Settings:
Function:
NMEA-HCHDM = NMEA sentence $..HDM
NMEA-HCHDT = NMEA sentence $..HDT
NMEA-HCHDG = NMEA sentence $..HDG
Selects the magnetic heading output data format of the sensor data
interfaces (NMEA and RS 422).
If set to NMEA-HCHDT, the interface sends true heading derived from
magnetic heading by applying magnetic variation and deviation (talker-
ID HC) as well as true heading from the gyrocompass (talker-ID HE).
Receiving equipment must be able to discriminate between heading
data sources by their talker-IDs.
scale factor: 0.1 – 999.9 mV/°/min
damping time constant: 0 – 99 sec.
Sets the scale factor and the damping time constant for the analogue
rate of turn output.
The maximum output voltage of the analogue rate of turn output is
limited to ±10 V.
The damping time constant may also be set in the manual settings
menu.
No. of rudders: 1/2
scale factor 1/2: 0.1 – 99.9 mV/°
zero offset 1/2: -9.9° – +9.9°
Configures the rudder angle feedback inputs. If the number of rudders
is set to 1, only the feedback signal from feedback input 1 is read. If the
number of rudders is set to 2, feedback signals are read from both
feedback inputs.
The scale factor and zero-point offset can be set independently for
both feedback inputs.
The scale factors for C. PLATH rudder angle feedback units are:
49.7 mV/° for units with a rudder angle range of ±45°;
31.9 mV/° for units with a rudder angle range of ±70°.
056310
3-149 MK110ENG.P65
Page 4-09