Agria 5900 Bison Translation Of The Original Operating Instructions page 11

1 Safety Instructions
Do not use assist-starting liquids when
using electrical assist-starting devices
(jumper cable). Danger of explosion!
Operation
Never leave the operator's position at
the steering bar while working.
Never adjust operator bars while work is
in progress – risk of accident!
For all work with the device, especially
when turning, the machine operator
must maintain the distance from the
device shown by the bars.
Riding on the implement during opera-
tion or in transport is not permitted.
In the event of any clogging to the work
equipment or add-on device, the engine
must be stopped and the work equip-
ment or add-on device must be cleaned
with appropriate tools. There may be
tension in the drive train as a result of
the blockage, which is why you should
resolve the blockage carefully.
In the event of any damage to the ma-
chine or the add-on device, shut down
the engine immediately and have the
damage repaired.
In the event of any malfunctions to the
steering, stop and park the machine
immediately. Have the fault resolved
without delay.
If there is a risk of skidding down on
sloping terrain, then the machine must
be held by an attendant using a bar or a
rope. The attendant must be located
above the machine at a safe distance
from the work equipment.
Work across the slope along contour
lines if possible. If possible, turn the
machine in uphill direction.
Finishing work
Never leave the machine unsupervised
while the engine is running.
Switch the engine off before leaving the
machine. Then close the fuel tap(s) (if
present).
Hydrostatic Implement Carrier agria 5900 Bison
Take care not to park the hot machine in
the blazing sun.
Protect the machine against unauthor-
ized use. In ignition key models, remove
the ignition key; otherwise, remove the
spark plug connector.
Implements
Attach an implement only when engine
and implement drive are switched off.
Prior to attaching and starting the im-
plement, read and observe the operating
instructions of the implement.
Use adequate tools and wear gloves to
replace implements and parts thereof.
Put the supporting equipment to the
proper position and ensure stability
when you attach or remove an imple-
ment.
Secure machine and implements against
rolling away (parking brake - if installed,
wheel chocks).
There is a risk of injuries when you at-
tach an implement. Take special care.
Attach an implement in accordance with
the regulations and only at the specified
fixtures.
Always switch off the working tools dur-
ing a transport ride or when you drive to
adjacent working areas.
Secure machine and implement against
unauthorized use and rolling away when
you leave it. If
transport or safety equipment, and put it
in protective position.
Mowing equipment
When handled improperly, the sharp
edges of the mower knives can cause
significant injuries. Always wear protec-
tive gloves when you work on the
knives.
Ensure that the screwing movements
are away from the cutting edges when
you replace a knife and loosen or secure
the knife driver.
necessary, install
11