Supermicro A2SAP-L1 User Manual page 55

Power Limit 1 Clamp Mode
Use this feature to enable or disable Power Limit 1 Clamp Mode. The options are Dis-
abled and Enabled.
Power Limit 1 Power
Use this feature to select Power Limit 1 power (in watts). Auto will program Power Limit
1 based on silicon default support value. The options are Auto, 6, 7, 8, 9, 10, 11, 12,
13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, and 25. .
Power Limit 1 Time Window
Use this feature to select Power Limit 1 time window (in seconds). Auto will program
Power Limit 1 time window based on silicon default support value. The options are Auto,
1, 2, 3, 4, 5, 6, 7, 8, 10, 12, 14, 16, 20, 24, 28, 32, 40, 48, 56, 64, 80, 96, 112, and 128.
Active Processor Cores
Use this feature to select the number of cores to enable for each processor. The options
are Disabled and Enabled.
Intel Virtualization Technology
Select Enabled to use Intel Virtualization Technology to allow one platform to run multiple
operating systems and applications in independent partitions, creating multiple virtual
systems in one physical computer. The options are Disabled and Enabled.
VT-d
Select Enable to use Intel Virtualization Technology for Direct I/O VT-d support by reporting
the I/O device assignments to the Virtual Machine Monitor (VMM) through the DMAR
ACPI tables. This feature offers fully-protected I/O resource sharing across Intel platforms,
providing greater reliability, security, and availability in networking and data-sharing. The
options are Enabled and Disabled.
Monitor MWait
Select Enabled to enable the Monitor/Mwait instructions. The Monitor instructions monitors
a region of memory for writes, and MWait instructions instruct the CPU to stop until the
monitored region begins to write. The options are Disabled, Enabled and Auto.
P-STATE Coordination
Use this feature to change P-STATE Coordination type. The options are HW_ALL, SW_
ANY, and SW_ALL.
55
Chapter 4: BIOS