Table of Contents
Advertisement
S Y S T E M M E N U
DMX Settings
Select DMX Settings, then press the ENTER button to confirm. Use the UP/DOWN button to select
DMX Address, DMX Channel Mode, or No DMX Status.
DMX Address —DMX512 address setting
Select DMX Address, then press the ENTER button to confirm. Use the UP/DOWN button to adjust
the address from 001 to 512, then press the ENTER button to store. Press the MENU button back
to the last menu or let the unit idle one minute to exit menu mode.
DMX CH Mode — channel mode
Select DMX CH Mode, then press the ENTER button to confirm. Use the UP/DOWN button to select
14ch, 15ch, 17ch, 18ch, 19ch, 38ch, 39ch, 72ch, and 73ch, then press the ENTER button to store.
Press the MENU button to move back to the last menu, or let the unit idle one minute to exit menu
mode.
No DMX Status — fixture state while DMX single stops
Select No DMX Status, then press the ENTER button to confirm. Use the UP/DOWN button to
select Hold Last (fixture continues to obey the last command it received Via DMX if DMX signal
stops), Blackout (fixture blacks out if DMX signal stops), Int Program, or Manual (fixture take all
channels to the last set Manual channel settings if DMX signal stops), then press the ENTER button
to store. Press the MENU button to move back to the last menu, or let the unit idle one minute to exit
menu mode (In the state of Blackout/ Hold Last, when there is no DMX signal, the unit will remain in
the final state within 15M, after which it will enter the static mode. The unit will remain in the final state
within 15M. After 15M, it will enter the static mode. At this time, the lamp will turn off, and the motor will
stop working. When the DMX signal is reconnected, the unit will be automatically activated and reset).
Personality
Select Personality, then press the ENTER button to confirm. Use the UP/DOWN button to select
Status Settings, Fan Settings, Dim Modes, Dim Curve, Reset Motors, Display, or Service.
Status Settings
Select Status Settings, then press the ENTER button to confirm. Use the UP/DOWN button to select
Pan Invert, Tilt Invert, P./T. Feedback, P./T. Speed, or Hibernation, then press the ENTER button
to store. Press the MENU button to move back to the last menu, or let the unit idle one minute to exit
menu mode.
Pan Inverse
Select Pan Inverse, then press the ENTER button to confirm. Use the UP/DOWN button to select
ON (normal) or OFF (pan inverse), then press the ENTER button to store. Press the MENU button
to move back to the last menu, or let the unit idle one minute to exit menu mode.
Tilt Invert
Select Tilt Invert, then press the ENTER button to confirm. Use the UP/DOWN button to select ON
(normal) or OFF (pan inverse), then press the ENTER button to store. Press the MENU button back
to the last menu, or let the unit idle one minute to exit menu mode.
P./T. Feedback
Select P./T. Feedback, then press the ENTER button to confirm. Use the UP/DOWN button to select
ON (normal) or OFF (pan inverse), then press the ENTER button to store. Press the MENU button
to move back to the last menu, or let the unit idle one minute to exit menu mode.
P./T. Speed
Select P./T. Speed, then press the ENTER button to confirm. Use the UP/DOWN button to select
Speed 1 or Speed 2, then press the ENTER button to store. Press the MENU button to move back
to the last menu, or let the unit idle one minute to exit menu mode.
22
Advertisement
Table of Contents
