Table of Contents
Advertisement
D M X A D D R E S S I N G
All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture
responds to the correct control signal. This digital starting address is the channel number from which
the fixture starts to "listen" to the digital control signal sent out from the DMX controller. The assignment
of this starting DMX address is achieved by setting the correct DMX address on the digital control
display on the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set different addresses for
each individual fixture. Setting all fixtures to the same DMX address will cause all fixtures to react in the
same way, in other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set each fixture to a different DMX address, each unit will start to "listen" to the channel number
you have set, based on the quantity of DMX channels of each fixture. That means changing the settings
of one channel will only affect the selected fixture.
In the case of the Vizi Wash Z37, when in 14 Channel Mode, you should set the starting DMX address
of the first unit to 1, the second unit to 15 (14 + 1), the third unit to 29 (15 + 14), and so on.
Channel Mode
14 Channels
15 Channels
17 Channels
18 Channels
19 Channels
38 Channels
39 Channels
72 Channels
73 Channels
Unit 1 Address
Unit 2 Address
1
1
1
1
1
1
1
1
1
Unit 3 Address
15
29
16
31
18
35
19
37
20
39
39
77
40
79
73
145
74
147
16
Unit 4 Address
43
46
52
55
58
115
118
217
220
Advertisement
Table of Contents
