Controls On The Rear Panel - ESAB PEI Instruction Manual

GB
3.2

Controls on the rear panel

DIRECT
START
EXT.
2,0s
1,6
BURN BACK
Mode setting (1)
Intended for setting DIRECT START or SCRATCH START modes.
DIRECT START
S
The feeder motor starts at minimal speed. The tractor is stopped. At the
moment of sensing the welding current, both motors start to operate with
pre--adjusted speeds.
SCRATCH START
S
Both the feeder motor and the tractor start at minimal speed. At the moment of
sensing the welding current both motors start to operate with pre--adjusted
speeds.
EXT.
S
Extension, which is not currently supported.
Burn- -Back time adjustment (2)
Intended for setting the burn--back time (maximum 2 seconds).
Adjustment is not active during welding. Setting is refreshed once per second.
fgc6d2ea
SCRATCH
START
0
0,4
0,8
1,2
6
- - 56 - -