Recovery Button - Oracle MICROS Workstation 6 Setup Manual

2. On the Advanced tab, use the arrow keys to select Special Configuration, and
3. Select Factory Recovery and press Enter.
4. Select Enabled and press Enter.
5. Press F10, select Yes, and press Enter to save configuration changes and exit the
6. After the Workstation 6 reboots, on the Choose an option screen, click
7. On the Troubleshoot screen, click Reset your PC and then click Next.
8. Click Fully clean the drive and then click Reset to finish restoring factory
9. When the Workstation 6 completes restoration and reboots, you can begin

Recovery Button

You can use the system recovery button on the Workstation 6 to restore system settings
without using a keyboard:
1. Power off the Workstation 6. Do not disconnect the power cable.
2. Press the recovery button using any object less than 2mm in diameter. You can
3. Power on the Workstation 6. It briefly powers on, restarts, and then shows the
4. On the Choose an Option screen, click Troubleshoot.
5. On the Troubleshoot screen, click Reset your PC, and then click Next.
6. Click Fully clean the drive, and then click Reset to finish restoring factory
7. When the Workstation 6 completes restoration and reboots, you can begin
40
Utility starts. If the workstation boots into the operating system without
starting the utility, restart the workstation and try again.
press Enter.
configuration utility.
Troubleshoot.
settings.
operating system setup.
access the button on the Workstation 6 using an opening on the adjustable stand
mount near the DC power cable. Make sure you are not using the opening for the
security screw.
Please Wait message below the splash screen.
settings.
operating system setup.
Troubleshooting