Bios Configuration; Starting The Bios System Configuration Utility; Viewing System Information; Configuring System Security Settings - Oracle MICROS Workstation 6 Setup Manual

BIOS Configuration

This section describes how to enter the BIOS System Configuration Utility and how to
configure the system BIOS.

Starting the BIOS System Configuration Utility

To configure the BIOS, start the BIOS System Configuration Utility using the following
steps:
1. Connect a USB keyboard to the Workstation 6.
2. Power on or restart the workstation.
3. Press F2 immediately after pressing the power button and before the BIOS splash

Viewing System Information

On the Main tab, use the arrow keys to select System Information, and press Enter.
The following is an example set of information presented by the BIOS system
information screen. The actual data shown by your system may vary:
•
•
•
•
•
•
•
•
•

Configuring System Security Settings

On the Security tab, configure the settings as described in the following table:

Table 3 - BIOS Security Settings

Setting
Secure Boot Configuration:
Set Supervisor Password
Supervisor Hint String
26
screen. You can tap F2 repeatedly until the Configuration Utility starts. If the
workstation boots into the operating system without starting the utility, restart
the workstation and try again.
BIOS Version: W1300h IA32
Build Time: 12/02/2014
Processor Type: Intel(R) Atom(TM) CPU E3827 @ 1.74GHz
Processor Speed: 1.757 GHz
System Memory Speed: 1333 MHz
L2 Cache RAM: 1024 KB
Total Memory: 4096 MB
[1]: 4096 MB (DDR3- 1333) @ DIMM0
[2]: 0 MB
Secure Boot Option
Reset to Default
Change to Customization
Description of Options
Enable or Disable the UEFI secure boot firmware
validation process.
Reset secure boot variables to the factory default.
Delete the protection key, change the platform to
setup mode, and disable secure boot.
Set or clear the supervisor password.
Enter a hint for the password.
Workstation 6 Utilities and Configurations