Testing An Idn Printer; Viewing Diagnostics Reports For Devices On Com Ports; Configuring Voltage For Usb Ports; Viewing Diagnostics Reports For I2C Devices - Oracle MICROS Workstation 6 Setup Manual

4. Verify that the Tx Bytes field and Rx Bytes field increments.
5. Tap Quit Test.

Testing an IDN Printer

On the IDN Print tab, you can test connectivity and print line-by-line at an IDN Roll
Printer with an ID of 1. You must have an RS422 (6 pin to 8 pin) cable.
1. Connect the 8-pin end to the workstation COM port 4.
2. Connect the 6-pin end to the printer IDN port 1.
3. Select COM4 from the Output Port drop-down list.
4. Tap Test Ports.
5. Verify that the Tx Bytes field and Rx Bytes field increments and that the printer
6. Tap Quit Test.

Viewing Diagnostics Reports for Devices on COM Ports

On the Devices tab, you can monitor and retrieve diagnostics reports or data from
selected peripheral devices.

Configuring Voltage for USB Ports

On the Hardware Control tab, you can:
•
•
•
By default, you can determine the password by applying the following formula to the
key:
For example, if the utility shows the key 532586, the password is 26 (5*3+5+6).

Viewing Diagnostics Reports for I2C Devices

On the I2C Devices tab, you can:
•
•
Workstation 6 Utilities and Configurations
continues printing line-by-line.
Enable or Disable USB ports.
Set the voltage level for the COM1 and COM2 ports.
Set the voltage level for the cash drawer port.
Digit 1 * Digit 2 + Digit 4 + Digit 6 = Password
Retrieve information from an RFID tag.
Retrieve data from EEPROM memory.
25