Optional Operation
Installer Setting-Dry Contact Mode Setting
This function is available only for the products with dry contact device.
B
Press and hold
button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Move to the Dry Contact Mode Settings in the menu using
then it displays as below.
Select the Dry Contact Mode using F G button.
Code value for
Set value
dry contact
K
Press
button to save the setting.
L
Press
button to exit.
h If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
K
h If the
button is not selected before you exit, the changes will not apply.
• See the Dry Contact manual for more detailed functions about dry contact mode.
▶ What is Dry Contact?
It means a contact signal received when an air conditioner runs interlocking with hotel key card
or sensor.
30
❈ Set value for dry contact
00 : Manual
01 : Auto
B
button and