Installer Setting-Remote Controller Master/Slave Setup - LG ABNW85GB9A0 Installation Manual

Installer Setting-Remote Controller Master/Slave Setup

This function is the settings when controlling 2-remote controls or group control.
B
Press and hold button for more than 3 seconds to enter the installer settings mode.
- If pressing only once briefly, it will enter the user settings mode.
Make sure to press and hold for more than 3 seconds.
Move to the Master/slave selection in the menu using
then it displays as below.
Select the remote control master/slave using F G button.
Code value for remote
control master/slave
K
Press button to save the setting.
L
Press button to exit.
h If no button is selected for about 25 seconds after setup, it exits the setup mode automatically.
K
h If the
button is not selected before you exit, the changes will not apply.
Remote control
01 Master
02 Slave
h See the 'Group control' section for more information about master/slave.
• Some functions may not be available during a group control except basic operation settings,
fan speed low/med/high, remote control lock setting, time setting.
❈ Set value for remote control
00 : Slave
01 : Master
Set value
The Indoor Unit run by master remote controller in case of group con-
trol. (Set as a master by default)
Set all the remote controllers as slaves except one master remote
control for group control.
B
button and
Function
Optional Operation
Installation Manual 29