Preparation; Unpacking The Product; Assembling The Product; Connecting The Power Supply - Storz 8404ZX Instructions For Use Manual

5 Preparation

5.1 Unpacking the product

1. Carefully remove the product and accessories from the packaging.
2. Check the delivery for missing items and any possible damage.
3. In the case of damage, hidden defects, and short deliveries, document their nature and
extent and contact the manufacturer or supplier immediately.
4. Keep packaging for further transport.

5.2 Assembling the product

Attaching the monitor to the stand
To attach the monitor to a stand, use VESA 75 Quick Clip stand holder 8401YCA and, as an
option, clamp 8401YB, Accessories.
1. Attach the stand holder to the back of the monitor using 4 screws.
2. Press together the holder and slide the holding arm through the holder.
3. Release the holder in the desired position.
ð The monitor is secured in place on the holding arm.

5.3 Connecting the power supply

The C-MAC Monitor can be powered using either a connected power supply unit or the
integrated lithium-ion battery.
1. Before each use, ensure that the power supply to the monitor for the planned procedure
is provided either by the battery or by a connected power supply unit.
2. If power is supplied by the battery, check the battery charge state on the status bar
(Monitor status bar) and charge the battery if necessary.
Battery charging time and life
The battery can be used for approx. 2 hours when fully charged and will last for approx. 4–
5 hours on standby mode. The battery life may be shorter depending on the components and
functions used.
Recharge the battery:
– After each use of the device
– Whenever the charge state falls below 50%
Instructions for use • C-MAC Monitor • CFH518_EN_V1.0_12-2021_IFU_CE-MDR
Preparation
20