Figure 6 - Dielectric Strength Testing - RuggedCom RuggedSwitch RS940G Installation Manual
8-port managed gigabit ethernet switch
Hide thumbs
Also See for RuggedSwitch RS940G:
- Specification sheet (9 pages) ,
- Specification sheet (8 pages)
Table of Contents
Advertisement
Installation
2.2.3 Dielectric Strength Testing
Units which are to have dielectric strength testing (HIPOT testing) done in the field must have the
braided ground cable disconnected during the test. This is required in order to prevent the surge
suppression circuitry, which is connected to surge ground, from being activated.
Figure 6 - Dielectric Strength Testing
12
RuggedCom
RuggedSwitch
RS940G Installation Guide rev101
®
®
Advertisement
Table of Contents
Need help?
Do you have a question about the RuggedSwitch RS940G and is the answer not in the manual?
Questions and answers