Ethernet Panel Description; Figure 12: Sfp Bail Latch Location; Figure 13: Sfp Removal; Figure 14: Copper Port Led Description - RuggedCom RuggedSwitch RS940G Installation Manual
8-port managed gigabit ethernet switch
Hide thumbs
Also See for RuggedSwitch RS940G:
- Specification sheet (9 pages) ,
- Specification sheet (8 pages)
Table of Contents
Advertisement
Installation
Figure 12: SFP Bail Latch location
2.6 Ethernet Panel Description
Each copper Ethernet port, is equipped with two built-in LED that indicates speed and link/activity
status information. The speed LED will be on for ports that are operating in 1000BaseTX mode,
and off for ports operating in 10/100BaseTX mode. The link/activity LED will be solid for ports with
link, and will blink for activity. The diagram in Figure 14 highlights the port and the associated
speed and link/activity LED.
Figure 14: Copper Port LED Description
Each copper Ethernet port, is equipped with one LED that indicates link/activity status information.
The LED will be solid for ports with link, and will blink for activity. The diagram in Figure 15
highlights the port and the associated link/activity LED.
Figure 15: Fiber Port LED Description
Status LED
Speed LED
RuggedCom
®
Colour
Yellow
18
RuggedSwitch
Figure 13: SFP Removal
Activity
Off
On
RS940G Installation Guide rev101
®
Comments
10/100 Mbps
1000 Mbps
Advertisement
Table of Contents
Need help?
Do you have a question about the RuggedSwitch RS940G and is the answer not in the manual?
Questions and answers