Table of Contents
Advertisement
11. INSTALLING THE LIGHT
KIT
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the 1 of 3 screws from the
mounting plate and keep it for future use.
Loosen the other 2 screws (Do not remove).
Step 2. Raise and hold the light kit close to
the mounting plate and proceed to do the
wire connections. Connect the white wire
connectors from the light kit and fan, follow
the same procedure with the black wire
connectors. (Fig. 19)
Step 3. Tuck connections neatly into
mounting plate, Place the light plate key
holes over the 2 screws previously loosened
from the mounting ring, turn light kit until it
locks in place at the narrow section of the key
holes, secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 19)
12. INSTALLING THE LIGHT
BULB & GLASS SHADE
1. Install 2 x E27/9W LED bulb (included).
2. Raise glass shade up against the mounting
plate and secure it to fan by turning glass
clockwise until snug. Do not overtighten.
(Fig. 20) WARNING: The metal light cover
included with your fan is an option to replace
the glass for the light in the event that you
prefer not to use the light feature of your fan.
The metal light cover is not necessary for the
light operation; it can be saved for later use if
desired.
3. Restore power and your light kit is ready for
operation.
Connection
plugs
Light kit
Bulb
9
Screws
Figure 19
Glass shade
Figure 20
Advertisement
Table of Contents
