Table of Contents
Advertisement
Installing the NFPA label
NOTE: Each DEM680E comes with an NFPA exit
delay door label as required by fire code.
1
FOLLOW the included application instructions
to apply the lettering to a door.
Restoring factory
default settings
1
DISCONNECT power from the Magnalock.
2
REMOVE the cover using a Phillips screwdriver.
3
SET DIP-switch 10 (SW 10) to "ON" (see Diagram 40).
NOTE: When power is applied with SW 10 in the ON
position, previous calibration settings are erased. The LED
will continue to flash red until SW 10 is switched OFF.
4
APPLY power to the Magnalock and
verify that the LED flashes red.
5
SET SW 10 to OFF. The unit should auto-calibrate.
If the unit fails to calibrate see Troubleshooting
Guide, or contact technical support.
Warranty
For information on warranty coverage and replacement options, please visit securitron.com/warranty
12 of 12
techsupport.securitron@assaabloy.com
securitron.com | 800 626 7590
10027 S. 51st Street Phoenix, AZ 85044 USA
Diagram 40 Setting DIP-switch 10 to ON
Dip Switch 10 – ON
Patent pending and/or patent www.assaabloydss.com/patents
Copyright © 2022, Hanchett Entry Systems, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Hanchett Entry Systems, Inc. is prohibited. 500-23800_1
Printed in the U.S.A.
Advertisement
Table of Contents
