Table of Contents
Advertisement
Performing a
pre-installation survey
1
Before installing the Magnalock, determine and
assess the mounting location for the following:
• Physical strength of the frame — should
be strong enough to meet or exceed the
holding force of the Magnalock.
• Frame and vicinity — should offer protection
for the wiring to prevent vandalism, and provide
adequate protection from rain exposure.
• Door inspection — inspect for any obstacles
that may interfere when mounting the strike
plate and ensure that there is minimum door
movement when the door is latched.
• Proper mounting —The Magnalock comes
with factory default mounting hardware
for use with an out-swing door.
Preparing the Magnalock
1
Ensure that there is at least 2-1/4" between
the closed door and the edge of the header.
If not, a header bracket (sold separately)
may be required (see Diagram 2).
Removing the cover
and mounting bracket
1
Using a Phillips screwdriver, REMOVE the two
(2) screws that secure the cover, as shown in
Diagram 3a, and the (3) screws that secure
the mounting bracket to the top of the
lock chassis as shown in Diagram 3b.
2
SET the cover and screws aside to re-attach later.
3
SLIDE the bracket to disengage from
the top of the lock chassis.
Marking the frame
1
PINCH and insert the template pins
flush into the dovetail slots of the
mounting bracket (see Diagram 4).
2
APPLY MASKING TAPE to the door and
frame surfaces to protect from any possible
damage during marking and drilling.
3
PLACE the mounting bracket against the frame stop
on the secure side of the door and on the side of the
door that does not have hinges. Ensure that there
is a minimum a clearance of 1" from the frame.
4
CLOSE the door and adjust the bracket so that
the template pins rest against the door.
2 of 12
Diagram 2 Assessing the installation site
1-1/8"
Bracket
Mounting
Surface
Anchor Screws
A
Diagram 3a Removing the cover
Diagram 3b Removing
the mounting bracket
Diagram 4 Inserting
the template pins
2-1/4" from door to trailing
edge of bracket
1-11/16" from
door to center
of bracket slots
1/4-20
Blind Nut
Diagram 5 Marking the frame
1" Min.
A
Advertisement
Table of Contents
